Dr. Z having a problem powering up a air handler on a a/c only system that is powered by a conventional condensor not a heat pump ? I get power at the red link board but no fan? Tried several things out of ideas? What do you suggest?
Yes, my camera took yet another oil bath. I’m really hard on my camera. I’m lucky that it’s been so forgiving. Pro-Flush works great on preparing line sets for R-22 to R-410 conversions.
I was able to clean the coil to my satisfaction. As far as if I was able to remove all of the flush, I’m sure that the vacuum pump was able to evaporate any thing that remained. The evaporative temperature of Pro-Flush is 75 degrees F.
Check to be sure that the fan relay is getting control voltage.
Dr. Z having a problem powering up a air handler on a a/c only system that is powered by a conventional condensor not a heat pump ? I get power at the red link board but no fan? Tried several things out of ideas? What do you suggest?
Yes, my camera took yet another oil bath. I’m really hard on my camera. I’m lucky that it’s been so forgiving. Pro-Flush works great on preparing line sets for R-22 to R-410 conversions.
Did you get Pro Flush on you video camera? Can you use this to remove mineral oil from a line set that you are converting from R-22 to R-410a?
I was able to clean the coil to my satisfaction. As far as if I was able to remove all of the flush, I’m sure that the vacuum pump was able to evaporate any thing that remained. The evaporative temperature of Pro-Flush is 75 degrees F.